Qualcomm OBDII J1708 Guide de dépannage Page 39

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 110
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 38
80-JB566-1 Rev. C 11-1
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
11
Display Screen is Dark or Blank
Problem: Display Screen is Dark or Blank
If the display is blank or dark it could be:
Unit is asleep (i.e. ignition off, and power down timer exceeded)
Power source or Power/IO cable problem
Ignition source or ignition wire problem
Display cable is disconnected from VTM
Faulty DIU
Turn the vehicle ignition ON.
1. Check to see if the LED on the VTM50 is blinking red as unit boots up.
If it is not blinking, reseat the Power/IO connection at the VTM. If the LED is still not
blinking, use a digital volt meter to check for power and ignition at the truck’s
diagnostic connector. Pin-outs for the 6-pin and 9-pin connectors are in the Appendix
A: Wiring Diagrams and Charts
Verify, using a digital volt meter, that the ignition circuit, fuse, and source are
functioning properly. 12 VDC should be detected when the truck’s ignition key is in
the ON position.
2. If there is still a problem, remove power from VTM, reseat the display cable connector
at the VTM, and then reapply power to the VTM.
Vue de la page 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 109 110

Commentaires sur ces manuels

Pas de commentaire